How to Fix Geek Bar Pulse Auto Firing Out of the Box?

If your Geek Bar Pulse is auto-firing straight out of the box, don’t worry — you’re not alone! This common issue can be easily resolved with a few simple steps. Below, we’ll dive into the causes, solutions, and tips to ensure your Geek Bar operates smoothly.

What Causes Geek Bar Pulse Auto-Firing?

1. Juice Residue Accumulation

Over time, juice residue can build up inside the device, causing the pressure slider to stick in the “on” position. This tricks the device into thinking you’re actively using it, leading to continuous firing.

2. Sticky Pressure Switch

The pressure switch may become sticky due to dust or juice leakage, preventing it from functioning properly.

How to Fix Geek Bar Pulse Auto-Firing?

Here are four tried-and-true solutions, including detailed steps for each method.

1. Blow Gently Into the Mouthpiece

Gently blow into the mouthpiece. This can help loosen the sticky trigger slider.
Check if the auto-firing stops after this simple step.

2. Tap or Block Both Ends

Lightly tap the device to dislodge any stuck components.
Alternatively, block both ends of the device (mouthpiece and airflow vent) to temporarily stop airflow and reset the pressure mechanism.

3. Keep It Away from Flammable Objects

If the device is firing uncontrollably, place it on a non-flammable surface to avoid safety risks.

4. Use a Compressed Air Burst

Use a can of compressed air or an air compressor to clean the device.
Blow air into the mouthpiece with short bursts of 1 second each (70–200 PSI).
Tip: Avoid prolonged bursts as it may burn the coil.
Test the device after each burst. If it continues to auto-fire, repeat the process until resolved.

Visual Instructions

(Include a step-by-step image guide here for better understanding. For example, illustrate blowing into the device, tapping it, and using compressed air.)