Is your Geek Bar Pulse malfunctioning with auto-firing right out of the package? Don’t worry — you’re not alone! Many users experience this problem, but it’s easily fixable with a few straightforward steps. In this guide, we’ll explore the causes of auto-firing and provide detailed solutions to get your Geek Bar working perfectly again.
Why Does Geek Bar Pulse Auto-Fire?
1. E-Liquid Residue Buildup
Over time, e-liquid residue can accumulate within the device. This buildup causes the pressure slider to stick, making the device think it’s in use and resulting in continuous activation.
2. Malfunctioning Pressure Switch
Dust or juice leakage can make the pressure switch sticky, preventing it from operating properly.
How to Fix Geek Bar Pulse Auto-Firing?
Here are four effective solutions to resolve the auto-firing issue:
1. Blow Gently into the Mouthpiece
- Gently blow into the mouthpiece to loosen the sticky trigger slider.
- Check if the auto-firing stops.
2. Tap or Block Both Ends
- Lightly tap the device to dislodge any obstructed components.
- Alternatively, block both the mouthpiece and airflow vent to halt airflow temporarily and reset the internal system.
3. Keep It Away from Flammable Surfaces
- If the device continues to fire uncontrollably, place it on a heat-resistant surface to avoid accidents.
4. Use Compressed Air
- Use a can of compressed air or an air compressor to clean the device.
- Blow short bursts (1 second each, at 70–200 PSI) into the mouthpiece.
- Note: Avoid prolonged bursts to prevent damaging the coil.
- Test the device after each burst. If the issue persists, repeat until resolved.
Step-by-Step Visual Instructions
(Include clear images or diagrams for blowing into the mouthpiece, tapping the device, and using compressed air for better understanding.)
Where to Buy Geek Bar Pulse?
Looking for a genuine Geek Bar Pulse? Visit Kloudyx for a wide selection of authentic products, including:
- Mystery Boxes
- Value Packs
- Holiday Promotions
- Discounted Deals
Join the Discussion on Reddit
Want more insights and troubleshooting tips? Check out this discussion by fellow vapers:
Geek Bar Auto-Firing Issue — Reddit
Tips to Prevent Future Auto-Firing Issues
- Regularly clean your Geek Bar Pulse to remove e-liquid residue.
- Handle the device with care to avoid damaging its internal components.
By following these simple steps, you can fix the auto-firing issue and enjoy your Geek Bar Pulse without any interruptions.
